HP XP7 Storage - Manual (Page 211)

SLPR of the command device. In this case, -p CL3-A must be operated via RMINST1, as shown in
the following example.
Figure 69 Operation across SLPRs using two command devices on a single host
To operate SLPR#N, share the command device. If RMINST1 has a shared command device for
SLPR#N, the paircreate command is permitted. Additionally, the raidscan -p CL3-A
command (via RMINST0), is permitted to scan a port, because the shared command device has
the Bitmap settings SLPR#M and SLPR#N.
Figure 70 Operation across SLPRs using a shared command device on a single host
Dual Hosts
In the following example, the paircreate command is unable to operate the paired volume
because the volume described on HostB is different than the SLPR of the command device. Also,
the raidscan -p CL3-A command (via both Hosts), is unable to scan a port because the
specified port is different than the SLPR of the command device.
Using RAID Manager SLPR security 211