HP XP7 Storage - Manual (Page 266)

Table 81 SSB codes returned by raidcom add snapshot (continued)
raidcom add snapshot
Description Error code Executing/Async Error message
SSB2 SSB1
The specified pair operation cannot be performed for the
specified pool. 6004 2E13 Executing CMDRJE
The consistency group to be used in the specified Snapshot
Group is in one of the following status: 9900 2E13 Executing CMDRJE
•
The number of pairs that can be defined in a consistency
group exceeds the maximum.
•
The pair created by using the same P-VOL already exists
in the specified consistency group.
The specified LDEV is not defined. 0000 2E20 Executing CMDRJE
The command ends abnormally because an unmounted
volume is specified as the P-VOL of a Fast Snap or Snapshot
pair. 0008 2E20 Executing CMDRJE
The command ends abnormally because the blocked
volume is specified as the P-VOL of a Fast Snap or Snapshot
pair. 0009 2E20 Executing CMDRJE
The command ends abnormally because the volume in
formatting operation is specified as the P-VOL of a Fast
Snap or Snapshot pair. 000A 2E20 Executing CMDRJE
The command ends abnormally because an unmounted
volume is specified as the S-VOL of a Fast Snap or Snapshot
pair. 000B 2E20 Executing CMDRJE
The command ends abnormally because the blocked
volume is specified as the S-VOL of a Fast Snap or Snapshot
pair. 000C 2E20 Executing CMDRJE
The command ends abnormally because the volume in
formatting operation is specified as the S-VOL of a Fast
Snap or Snapshot pair. 000D 2E20 Executing CMDRJE
The command ends abnormally because the shared
memory (FC, TPF, or Extension1) is not expanded for
necessary capacity. 8107 2E21 Executing CMDRJE
The command ends abnormally because the shared
memory (SS1 or more) is not expanded for necessary
capacity. 8108 2E21 Executing CMDRJE
A Fast Snap or Snapshot pair cannot be created due to
one of the following reasons: 8109 2E21 Executing CMDRJE
•
The shared memory is not expanded for necessary
capacity.
•
It is in the initializing process.
The program product is not installed. 9010 2E21 Executing CMDRJE
A pair cannot be created because the volume is already
used in the S-VOL of a Fast Snap or Snapshot pair is
specified as the P-VOL. 0076 2E30 Executing CMDRJE
A pair cannot be created because the volume is already
used in the P-VOL of a Fast Snap or Snapshot pair is
specified as the S-VOL. 0077 2E30 Executing CMDRJE
266 Troubleshooting