HP 3000 Enterprise Virtual Array - Manual (Page 44)

Storage System Startup
44 Enterprise Virtual Array 3000 User Guide
If you enter an incorrect WWN or checksum, the data will be rejected and you
must repeat the procedure.
Note: An active (Flashing) display, an error condition, or a user entry (pressing a
pushbutton) overrides the default display.
When none of these conditions exist, the default display appears after approximately
15 seconds.
Setting the Storage System Password
The eight-character, alphanumeric storage system password feature enables you to
restrict certain functions to selected Command View EVA management agents.
Table 5 describes the pushbutton functions when using the password feature.
Complete the following procedure to set the password. In this sample procedure,
the password JWMFZJJP is entered.
Table 5: OCP Password Pushbutton Functions
Button Function
S
Select a password character by scrolling up through the character list
one character at a time.
T
Select a password character by scrolling down through the character
list one character at a time.
X
■
Move from the default display to the system menu tree.
■
Move from the system password display to the password entry
display.
■
Accept the current character and select the next character.
If you accept an incorrect character, you can loop through the
display, one position at time, to select the character to be changed.
W
Accept all the password characters.