HP 3000 Enterprise Virtual Array - Manual (Page 201)

Customer Replaceable Units
201 Enterprise Virtual Array 3000 User Guide
Installing a Drive Blank
Complete the following procedure to replace a disk drive with a drive blank.
1. Push in the disk drive Ejector Button, 1 in Figure 72 . Pivot the Release Lever
2 to the full, open position.
Figure 72: Removing a drive to install a drive blank
2. Pull on the drive to disconnect it from the backplane connector.
Caution: Rapidly rotating media can make the disk module difficult to handle.
To avoid dropping and damaging the drive, wait approximately 30 seconds
for the media to stop rotating before removing the drive from the enclosure.
3. When you are sure that the media is no longer spinning, remove the drive
from the enclosure.
CXO6826A
1
2