HP 3000 Enterprise Virtual Array - Manual (Page 192)

HSV Controller Fault Management
192 Enterprise Virtual Array 3000 User Guide
Fault Management Displays
When you do not have access to Command View EVA, you can display and
analyze termination codes (TCs) on the OCP LCD display. You can then use the
event text code document, as described in “
Interpreting Fault Management
Information ” on page 193 to determine and implement corrective action. You can
also provide this information to the HP authorized service representative should
you require additional support. This lets the service provider identify the tools and
components required to correct the condition in the shortest possible time.
When the Fault Management display is active (Flashing), you can either display
the last fault or display detailed information about the last 32 faults reported.
Displaying Last Fault Information
Complete the following procedure to display Last Fault information:
1. When the Fault Management display is
active (Flashing), press X to select the Last
Fault menu.
Last Fault
Detail View
2. Press X to display the last fault information.
TC: 0406017F IDX: 00
Param 0: 55555555
The first line of the TC display contains the eight-character TC error code
and the two-character IDX (index) code. The IDX is a reference to the
location in the TC array that contains this error.
The second line of the TC display identifies the affected parameter with a
two-character parameter number (0–30), the eight-character parameter code
affected, and the parameter code number.
3. Press W to return to the Last Fault menu.