HP EVA P6000 Storage - Manual (Page 290)

Table 35 iSCSI or iSCSI/FCoE module log messages (continued)
iSCSI driver missed iSCSI processor heartbeat.
iSCSI processor rebooted. Fatal iSCSI #%d: QLRebootTimer: Reboot
failed! 70563
iSCSI processor failed to complete operation before
timeout. Fatal iSCSI #%d: QLRebootTimer: Reboot
failed!
70564
iSCSI processor system error restart. Fatal iSCSI #%d: QLRebootTimer: Reboot
failed!
70609
iSCSI processor reboot failed. Fatal iSCSI #%d: QLProcessSystemError:
RebootHba failed
70610
iSCSI processor NVRAM invalid (checksum error). Fatal iSCSI #%d: QLConfigChip: invalid
NVRAM
70784
iSCSI controller Set Flash command failed. Fatal iSCSI #%d: QLStartFw:
MBOX_CMD_SET_FLASH failed
%x
70835
iSCSI controller failed to load firmware. Fatal iSCSI #%d: QLStartFw: Invalid Fw
loader state 0x%x
70836
iSCSI controller firmware load operation timed out. Fatal iSCSI #%d: QLStartFw: Load Fw
loader timeout
70837
iSCSI controller failed to initialize. Fatal iSCSI #%d: ql_adapter_up: Failed
to initialize adapter
70938
iSCSI controller reported that an SNS response had
an invalid handle. Fatal iSCSI #%d:
QLProcSrblessiSNSResponse:
Invalid handle %x
72351
iSCSI processor failed firmware initialization. Error iSCSI #%d: QLUtmIoctlEnable:
Initialize FW failed
73990
iSCSI processor failed the internal loopback test. Error iSCSI #%d: QLRunDiag: MBOX Diag
test internal loopback
failed %x %x
74056
iSCSI processor failed the external loopback test. Error iSCSI #%d: QLRunDiag: MBOX Diag
test external loopback
failed %x %x
74057
iSCSI processor reported an invalid Accept Target
I/O (ATIO) Continuation type x. Error iSCSI #%d: QLUtmReceiveScsiCmd:
Invalid ATIO Continuation
type %x
74068
iSCSI processor reported an Immediate data
address (xxxxxxxx:xxxxxxxx) in an unsupported
PDU Type. Error iSCSI #%d:
QLUtmProcessResponseQueue:
Immediate data addr
74069
%08x:%08x in unsupported
PduType
iSCSI processor could not connect with the iSCSI
name server (iSNS). Error iSCSI #%d: QLiSNSEnableCallback:
iSNS Server TCP Connect
failed
74241
iSCSI processor reported that the iSCSI port NVRAM
contains invalid data (checksum error). Error iSCSI #%d: QLIsrDecodeMailbox:
NVRAM invalid
74577
iSCSI processor reported a duplicate IP address
was detected (address xxxx xxxx xxxx xxxx xxxx). Error iSCSI #%d: QLIsrDecodeMailbox: AEN
%04x, Duplicate IP address
74580
detected, MB[1-5] %04x %04x
%04x %04x %04x
iSCSI processor reported a link down condition. Error iSCSI #%d: QLIsrDecodeMailbox:
Link down
74587
290 iSCSI and iSCSI/FCoE module log messages