Storage setup for apple mac os x, Iscsi initiator setup for linux – HP EVA P6000 Storage User Manual
Page 109
Storage setup for Apple Mac OS X
1.
Present LUNs using HP P6000 Command View.
2.
Verify that the EVA LUNs are presented to the Macintosh iSCSI Initiator:
a.
Open the Xtend SAN iSCSI application.
b.
Select the iSCSI or iSCSI/FCoE module target entry under the host name.
c.
Click the LUNs button.
A list of presented EVA LUNs is displayed (
).
Figure 49 Presented EVA LUNs
NOTE:
If no LUNs appear in the list, log out and then log in again to the target, or a
system reboot may be required.
3.
Set up the iSCSI drive on the iSCSI Initiator:
a.
Open Disk Utilities from the Apple Mac OS X Finder Applications list.
b.
Format and partition the EVA LUN as needed.
iSCSI Initiator setup for Linux
Installing and configuring the SUSE Linux Enterprise 10 iSCSI driver
Configure the initiator using the built-in GUI-based tool or the open-iscsi administration utility using
the iscsiadm command. See the iscsiadm (8) man pages for detailed command information.
1.
Modify the Initiator Name by issuing the following command:
# vi /etc/initiatorname.iscsi
2.
To configure the Initiator and Targets, start the iSCSI Initiator applet by finding it in the YaST
Control Center under Network Services, and then set the service to start at boot time
(
).
Set up the iSCSI Initiator 109