HP EVA P6000 Storage - Manual (Page 176)

Issue: Initiator cannot login to iSCSI or iSCSI/FCoE module target
Solution 1: Ensure the correct iSCSI port IP address is used
Solution 2: In HP P6000 Command View, for each iSCSI controller 01 and 02, click the IP ports
tab, then expand the TCP properties under the Advanced Settings. There should be available
connections; if not, choose another IP port to log in to or reduce the connections from other initiators
by logging out from unused connections (see
Figure 89 (page 176) ).
Figure 89 IP Ports tab
Issue: Initiator logs in to iSCSI or iSCSI/FCoE controller target but EVA assigned LUNs are not
appearing on the initiator
Solution 1. The initiator needs to log in to the target where the EVA LUN was assigned.
Solution 2. The EVA LUN was assigned to a different iSCSI Host then was expected.
Issue: EVA presented virtual disk is not seen by the initiator
Solution 1. The initiator has to login to the proper iSCSI target. Match the virtual disk presentation
properties as in
Figure 90 (page 177) and Figure 91 (page 177) to the initiator’s target login.
176 Troubleshooting