HP EVA P6000 Storage - Manual (Page 218)

Admin
Opens and closes an administrator (admin) session. Any command that changes the iSCSI or
iSCSI/FCoE module's configuration must be entered in an Admin session. An inactive Admin
session times out after 15 minutes.
Admin session Authority
start (or begin)
end (or stop)
cancel admin Syntax
Opens the Admin session. start (or begin) Keywords
Closes the Admin session. The logout, shutdown, and reset
commands also end an Admin session. end (or stop)
Terminates an Admin session opened by another user. Use this
keyword with care because it terminates the Admin session without
warning the other user and without saving pending changes. cancel
NOTE: Closing a Telnet window during an Admin session does not release the session. When
using Telnet, you must either wait for the Admin session to time out, or use the admin cancel
command.
Example: The following example shows how to open and close an Admin session:
MEZ50 <1>#> admin start
Password : config
MEZ50 <1> (admin) #>
.
.
.
MEZ50 <1> (admin) #> admin end
MEZ50 <1> #>
Beacon
Enables or disables the flashing of the blue UID beacon LED.
None Authority
on
off beacon Syntax
Turns on the flashing of the controller blue UID beacon. on Keywords
Turns off the flashing of the controller blue UID beacon. off
Example: The following example turns the controller blue UID beacon on and then off.
MEZ50 <1>#> beacon on
MEZ50 <1#> beacon off
Clear
Removes all entries (events) from the iSCSI or iSCSI/FCoE module's log file or resets the FC and
iSCSI statistic counters.
Admin session Authority
logs
stats clear Syntax
218 Command reference