HP EVA P6000 Storage - Manual (Page 127)

Figure 63 HBA Port Target Configuration
3. Repeat Steps 1 and 2 to add each additional iSCSI or iSCSI/FCoE target iSCSI port.
4. Click Next.
5. To enable the changes, enter the SMS password: config.
6. Select the Target Settings tab. Verify that the HBA state is Ready, Link Up and each target
entry’s state is Session Active (
Figure 64 (page 127) ).
Figure 64 Target Settings tab
Presenting LUNs to the QLogic iSCSI Initiator
To present LUNs to the QLogic iSCSI Initiator:
Set up the iSCSI Initiator 127