HP EVA P6000 Storage - Manual (Page 106)

Set up the iSCSI Initiator for Apple Mac OS X
1. Install the ATTO iSCSI Macintosh Initiator v3.10 following the install instructions provided by
the vendor.
2. Run the Xtend SAN application to discover and configure the EVA iSCSI targets. The Xtend
SAN iSCSI Initiator can discover targets either by static address or iSNS.
For static address discovery:
a.
Select Discover Targets and then select Discover by DNS/IP ( Figure 44 (page 106) ).
Figure 44 Discover targets
b. Add the static IP address of the iSCSI or iSCSI/FCoE module's port in the Address field
and then select Finish (
Figure 45 (page 106) ).
Figure 45 Add static IP address
c. Select a target from the Discovered Target list and then click Add ( Figure 44 (page 106) ).
NOTE: The iSCSI or iSCSI/FCoE module's port may present several iSCSI targets to
the Xtend SAN iSCSI Initiator. Select only one target from the list.
106 iSCSI or iSCSI/FCoE configuration rules and guidelines