HP EVA P6000 Storage - Manual (Page 139)

1. Enable CHAP for the iSCSI or iSCSI/FCoE controller discovered iSCSI Initiator entry. CHAP
can be enabled via CLI only.
To enable CHAP for the iSCSI or iSCSI/FCoE controller discovered iSCSI Initiator entry using
the iSCSI or iSCSI/FCoE controller CLI:
a.
If the iSCSI Initiator is not listed under the set chap command:
•
HP Command View Option: add the initiator iqn name string via the HP Command
View Add Host tab.
Go to HP Command View and select Hosts then select the Add Host tab and enter
the iqn name string.
•
CLI Option: Enter the initiator add command and add the iSCSI Initiator that
is about to do discovery.
b. If the iSCSI Initiator is listed under the set chap command, then enable CHAP secret.
For example: CHAPsecret01.
•
Select the index of the iSCSI Initiator.
•
To Enable CHAP, select 0, then enter the CHAP secret.
2. Enable CHAP for the iSCSI or iSCSI/FCoE controller iSCSI port:
a.
To enable CHAP for the iSCSI or iSCSI/FCoE controller iSCSI port using HP P6000
Command View:
•
Select the appropriate iSCSI Controller, then select the IP Ports tab, then select the
appropriate IP Port.
•
Under Security, select Enabled in CHAP Status, then enter the CHAP Secret. For
example, hpstorageworks
•
Click the Save Changes tab to save the changes.
b. To enable CHAP for the iSCSI or iSCSI/FCoE controller iSCSI port using the iSCSI or
iSCSI/FCoE controller CLI:
•
Enter the set chap command.
•
Select the appropriate Portal iqn name index that the initiator will log in to.
•
Select 0 to enable CHAP.
•
Enter a CHAP secret. For example: hpstorageworks.
Set up the iSCSI Initiator 139