HP XP7 Storage - Manual (Page 98)

The license key file will be deleted after the installation finishes.
3
.
Perform the installation.
¢
If you are not performing an unattended installation, insert the DVD
into the drive.
In the displayed window, click the Install button next to for
Windows of Hitachi Dynamic Link Manager.
If no window is displayed, manually run the installer (setup.exe).
The program checks whether HDLM has already been installed. If
HDLM 5.4 or earlier has been installed, the KAPL09129-E message will
appear. If this happens, carry out the procedure shown in Migrating
from HDLM 5.4 or Earlier to HDLM 5.5 or Later on page 3-66 . If
HDLM 5.5 or later has been installed, the KAPL09173-W message will
appear. If this happens, carry out the procedure shown in Upgrade
Installation or Re-installation of HDLM on page 3-64 . If no message
appears, go to step 4.
¢
If you are planning to perform an unattended installation, execute the
installhdlm utility.
At the command prompt, execute the following command:
drive-to-which-the-installation-DVD-is-inserted:\HDLM_Windows
\DLMTools\installhdlm -f installation-information-settings-
file
This command checks whether HDLM has already been installed. If
HDLM 5.4 or earlier has been installed, the KAPL09129-E message will
appear. If this happens, carry out the procedure shown in Migrating
from HDLM 5.4 or Earlier to HDLM 5.5 or Later on page 3-66 . If
HDLM 5.5 or later has been installed, the KAPL09183-E message will
appear, and then the upgrade installation or re-installation will be
performed.
If you have specified n for the restart key in the installation-
information settings file, go to step 11.
If you have specified y for the restart key in the installation-
information settings file, go to step 16.
4
.
The program checks the MPIO driver version, and then installs the MPIO
driver. If a message appears, asking you whether you want to install the
MPIO driver, make sure that no multi-path management software other
than HDLM is installed.
¢
If multi-path management software other than HDLM is installed, click
the Cancel button to cancel the installation, remove the multi-path
management software, and then install HDLM.
¢
If no multi-path management software other than HDLM is installed,
click the Next button to continue the installation.
5
.
Follow the instructions shown in the messages that appear in the window.
¢
If a license key file was saved in step 2, specify that license key file.
¢
If a license key file is not being used, specify the license key directly.
3-30
Creating an HDLM Environment
Hitachi Dynamic Link Manager (for Windows®) User Guide