The dlmchkpath utility for checking hdlm paths, Format, Parameters – HP XP7 Storage User Manual
Page 284: The dlmchkpath utility for checking hdlm paths -14, Format -14, Parameters -14, The dlmchkpath utility for, Utility, see, The dlmchkpath utility for checking hdlm

successful. (PRSV key = 0123456789abcdef)
PROMPT>
-s
Specify this parameter to avoid displaying a confirmation message
upon execution of the dlmprsvkey utility.
-v
Specify this parameter to display the registered PRSV key.
Example
PROMPT>dlmprsvkey -v
KAPL12116-I The registered PRSV key will now be displayed.
(PRSV key = 0123456789abcdef)
PROMPT>
-h
Displays the format of the dlmprsvkey utility.
If you do not specify any parameters, a warning message will appear.
The dlmchkpath Utility for Checking HDLM Paths
If you install or remove HDLM in a multi-path configuration, the disk might
become corrupted. Use the dlmchkpath utility to check HDLM paths and to
make sure that the system is in a single-path configuration. During an
upgrade installation, a re-installation, or removal of HDLM, the dlmchkpath
utility is executed automatically. If the system is in a single-path
configuration, the dlmchkpath utility displays nothing during an upgrade
installation, a re-installation, or removal of HDLM. A warning dialog box will
appear if the system is in a multi-path configuration.
However, when you use one of the following methods of installing HDLM and
the system is determined to be a multi-path configuration, the installation will
terminate without displaying any warning dialog boxes:
•
Upgrade installation using the unattended installation
•
Re-installation using the unattended installation
When the dlmchkpath utility is executed manually, a message will appear as
shown in the execution example in
located in the following location:
HDLM-installation-folder\bin
Format
dlmchkpath {-singleconnect | -h}
Parameters
-singleconnect
7-14
Utility Reference
Hitachi Dynamic Link Manager (for Windows®) User Guide