HP XP7 Storage - Manual (Page 132)

HDLM Version : x.x.x-xx
Service Pack Version :
Load Balance : on(extended lio)
Support Cluster : on MSCS
Elog Level : 3
Elog File Size (KB) : 9900
Number Of Elog Files : 2
Trace Level : 0
Trace File Size(KB) : 1000
Number Of Trace Files : 4
Path Health Checking : on(30)
Auto Failback : on(1)
Remove LU : off
Intermittent Error Monitor : off
Dynamic I/O Path Control : off(10)
HDLM Manager Ver WakeupTime
Alive x.x.x-xx yyyy/mm/dd hh:mm:ss
HDLM Alert Driver Ver WakeupTime ElogMem Size
Alive x.x.x-xx yyyy/mm/dd hh:mm:ss 128
HDLM Driver Ver WakeupTime
Alive x.x.x-xx yyyy/mm/dd hh:mm:ss
License Type Expiration
Permanent -
KAPL01001-I The HDLM command completed normally. Operation name
= view, completion time = yyyy/mm/dd hh:mm:ss
PROMPT>
24
.
Use the results of the view operation to check the version of the installed
HDLM.
If x.x.x-xx is displayed in HDLM Version, the correct version of HDLM
has been installed.
25
.
Use the results of the view operation to check that the programs are
running properly.
If HDLM Manager, HDLM Alert Driver, and HDLM Driver are all Alive,
all the programs are running correctly.
26
.
After the installation finishes, check the path information as described in
Checking the Path Configuration on page 3-70 , and make sure that you
have successfully installed HDLM in a single-path configuration.
27
.
Connect cables to all the HBAs to change the configuration to a multi-path
configuration.
28
.
Check the path information as described in Checking the Path
Configuration on page 3-70 to make sure that you have successfully
assembled a multi-path configuration.
Upgrade Installation or Re-installation of HDLM
You can perform an upgrade installation for only HDLM 5.5 or later. To
migrate HDLM 5.4 or earlier to version 5.5 or later, see Migrating from HDLM
5.4 or Earlier to HDLM 5.5 or Later on page 3-66 .
The procedure for an upgrade installation or re-installation is the same as for
a new installation of HDLM, with the exception of the following steps:
• Executing the dlmchkpath utility to check the HDLM paths.
3-64
Creating an HDLM Environment
Hitachi Dynamic Link Manager (for Windows®) User Guide