HP XP7 Storage User Manual
Page 131
HDLM-installation-folder\bin\dlmprsvkey -v
Make sure that the PRSV key displayed by the dlmprsvkey utility is
unique among all the other hosts in the SAN. If the PRSV key is not
unique or not registered, or if the KAPL09131-W message appears,
execute the dlmprsvkey utility with the -r parameter specified to re-
register the PRSV key. If the PRSV key is unregistered, the HDLM
functions might not properly operate. For details about the dlmprsvkey
The dlmprsvkey Utility for Registering an HDLM Persistent
. If you used a license key file, it will be
deleted after the installation finishes. The KAPL09115-W message will
appear if deletion of this file fails. If this happens, delete the file
manually.
12
.
If you want to select an EMC CX series or an HP EVA series LU as the
HDLM management-target device, perform the following steps to register
it. Otherwise, go to step 17.
13
.
From Control Panel, choose MPIO.
The MPIO Properties dialog box opens.
14
.
On the MPIO-ed Devices page, click the Add button.
The Add MPIO Support dialog box opens.
15
.
Enter the Device hardware ID, and then click the OK button.
¢
For an EMC CX series:
Enter DGC RAID for the Device hardware ID.Enter five single-byte
spaces between DGC and RAID.
¢
For an HP EVA series:
Enter HP HSV for the Device hardware ID.Enter six single-byte
spaces between HP and HSV.
16
.
Click the OK button to close the MPIO Properties dialog box.
17
.
Shut down the host.
Leave the host in a single-path configuration until you check (in step 26)
whether HDLM has been successfully installed.
18
.
Perform steps 1 to 17 on all the hosts that make up the cluster system.
19
.
Make sure that all the hosts that make up the cluster system have
completely shut down.
20
.
Modify the storage system settings.
Modify the storage system settings by following the procedure described
in the maintenance documentation for that particular storage system.
21
.
Restart each host.
22
.
Log on to Windows again as a member of the Administrators group.
23
.
Execute the dlnkmgr command's view operation to display the status of
each program.
Make sure that on MSCS is displayed in Support Cluster. An example of
executing the dlnkmgr command's view operation is as follows:
PROMPT>dlnkmgr view -sys
Creating an HDLM Environment
3-63
Hitachi Dynamic Link Manager (for Windows®) User Guide