HP XP7 Storage User Manual
Page 128
HDLM Alert Driver Ver WakeupTime ElogMem Size
Alive x.x.x-xx yyyy/mm/dd hh:mm:ss 128
HDLM Driver Ver WakeupTime
Alive x.x.x-xx yyyy/mm/dd hh:mm:ss
License Type Expiration
Permanent -
KAPL01001-I The HDLM command completed normally. Operation name
= view, completion time = yyyy/mm/dd hh:mm:ss
PROMPT>
24
.
Use the results of the view operation to check the version of the installed
HDLM.
If x.x.x-xx is displayed in HDLM Version, the correct version of HDLM
has been installed.
25
.
From the results of the view operation, check that the programs are
running properly.
If HDLM Manager, HDLM Alert Driver, and HDLM Driver are all Alive, all
the programs are running correctly.
26
.
After the installation finishes, check the path information as described in
Checking the Path Configuration on page 3-70
, and make sure that you
have successfully installed HDLM in a single-path configuration.
27
.
Connect cables to all the HBAs to change the configuration to a multi-path
configuration.
28
.
Check the path information as described in
to make sure that you have successfully
assembled a multi-path configuration.
29
.
Shut down the host.
30
.
Perform steps 21 to 29 on all the hosts that make up the cluster system.
31
.
Restart each host.
32
.
Install MSCS on each host.
33
.
Shut down all the hosts.
34
.
Restart each host again.
35
.
Log on to Windows as a member of the Administrators group.
36
.
Execute the dlnkmgr command's view operation to display the status of
each program.
Make sure that on MSCS is displayed in Support Cluster. An example of
executing the dlnkmgr command's view operation is as follows:
PROMPT>dlnkmgr view -sys
HDLM Version : x.x.x-xx
Service Pack Version :
Load Balance : on(extended lio)
Support Cluster : on MSCS
Elog Level : 3
Elog File Size (KB) : 9900
Number Of Elog Files : 2
Trace Level : 0
Trace File Size(KB) : 1000
Number Of Trace Files : 4
Path Health Checking : on(30)
3-60
Creating an HDLM Environment
Hitachi Dynamic Link Manager (for Windows®) User Guide