HP XP7 Storage - Manual (Page 119)

Trace Level : 0
Trace File Size(KB) : 1000
Number Of Trace Files : 4
Path Health Checking : on(30)
Auto Failback : on(1)
Remove LU : off
Intermittent Error Monitor : off
Dynamic I/O Path Control : off(10)
HDLM Manager Ver WakeupTime
Alive x.x.x-xx yyyy/mm/dd hh:mm:ss
HDLM Alert Driver Ver WakeupTime ElogMem Size
Alive x.x.x-xx yyyy/mm/dd hh:mm:ss 128
HDLM Driver Ver WakeupTime
Alive x.x.x-xx yyyy/mm/dd hh:mm:ss
License Type Expiration
Permanent -
KAPL01001-I The HDLM command completed normally. Operation name
= view, completion time = yyyy/mm/dd hh:mm:ss
PROMPT>
22
.
Use the results of the dlnkmgr command's view operation to check the
version of the installed HDLM.
If x.x.x-xx is displayed in HDLM Version, the correct version of HDLM
has been installed.
23
.
Use the results of the dlnkmgr command's view operation to check that
the programs are running properly.
If HDLM Manager, HDLM Alert Driver, and HDLM Driver are all Alive, all
the programs are running correctly.
24
.
After the installation finishes, check the path information as described in
Checking the Path Configuration on page 3-70 , and make sure that you
have successfully installed HDLM in a single-path configuration.
25
.
Connect cables to all the HBAs to change the configuration to a multi-path
configuration.
26
.
Check the path information as described in Checking the Path
Configuration on page 3-70 to make sure that you have successfully
assembled a multi-path configuration.
27
.
Shut down the host.
28
.
On all the hosts that make up the cluster system, perform steps 19 to 27.
29
.
Install and configure Oracle RAC.
If both of the following conditions are satisfied, you must change the
Oracle RAC settings after assembling the environment.
¢
Oracle RAC 10g 10.1.0.3.0 or later or Oracle RAC 11g is used.
¢
A host is connected to a voting disk via multiple paths in an FC-SAN
environment.
For details, see Notes on Creating an HDLM Environment on page 3-15 .
30
.
Make sure that the program is running properly, by examining the results
of the dlnkmgr command's view operation.
An example of executing the dlnkmgr command's view operation is as
follows:
Creating an HDLM Environment
3-51
Hitachi Dynamic Link Manager (for Windows®) User Guide