HP XP7 Storage User Manual
Page 122
¢
Although a message prompting you to restart the host appears after
the installation has finished, a restart is not necessary.
¢
In the last installation window, the following message might be
output:
When you manage a host by using Global Link Manager and
Windows firewall is enabled on that host, execute the
firewall_setup command to allow a firewall exception.
If Global Link Manager will not be used to manage HDLM, you do not
need to take any action.
To manage HDLM with Global Link Manager, register Firewall
exceptions. For details, see
Firewall Settings for Managing HDLM by
Using Global Link Manager on page 3-68
.
8
.
Check the results of the installation.
If you have performed an unattended installation, check the installation
results from the command prompt.
9
.
After the installation finishes, execute the dlmprsvkey utility with the -v
parameter specified.
Execute the following command:
HDLM-installation-folder\bin\dlmprsvkey -v
Make sure that the PRSV key displayed by the dlmprsvkey utility is
unique among all the hosts in the SAN. If the PRSV key is not unique or
not registered, or if the KAPL09131-W message appears, execute the
dlmprsvkey utility with the -r parameter specified to re-register the PRSV
key. If the PRSV key is unregistered, HDLM functions might not properly
operate. For details about the dlmprsvkey utility, see
Utility for Registering an HDLM Persistent Reservation Key on page 7-13
If you used a license key file, it will be deleted after the installation
finishes. The KAPL09115-W message will appear if deletion of this file
fails. If this happens, delete the file manually.
10
.
If you want to select an EMC CX series or an HP EVA series LU as the
HDLM management-target device, perform the following steps to register
it. Otherwise, go to step 15.
11
.
From Control Panel, choose MPIO.
The MPIO Properties dialog box opens.
12
.
On the MPIO-ed Devices page, click the Add button.
The Add MPIO Support dialog box opens.
13
.
Enter the Device hardware ID, and then click the OK button.
¢
For an EMC CX series:
Enter DGC RAID for the Device hardware ID.Enter five single-byte
spaces between DGC and RAID.
¢
For an HP EVA series:
Enter HP HSV for the Device hardware ID.Enter six single-byte
spaces between HP and HSV.
3-54
Creating an HDLM Environment
Hitachi Dynamic Link Manager (for Windows®) User Guide