HP XP7 Storage - Manual (Page 107)

33
.
Restart each host.
34
.
Log on to Windows again as a member of the Administrators group.
35
.
Make sure that the program is working normally running properly, by
examining the results of the dlnkmgr command's view operation.
Make sure that on MSCS is displayed in Support Cluster. An example of
executing the dlnkmgr command's view operation is as follows:
PROMPT>dlnkmgr view -sys
HDLM Version : x.x.x-xx
Service Pack Version :
Load Balance : on(extended lio)
Support Cluster : on MSCS
Elog Level : 3
Elog File Size (KB) : 9900
Number Of Elog Files : 2
Trace Level : 0
Trace File Size(KB) : 1000
Number Of Trace Files : 4
Path Health Checking : on(30)
Auto Failback : on(1)
Remove LU : off
Intermittent Error Monitor : off
Dynamic I/O Path Control : off(10)
HDLM Manager Ver WakeupTime
Alive x.x.x-xx yyyy/mm/dd hh:mm:ss
HDLM Alert Driver Ver WakeupTime ElogMem Size
Alive x.x.x-xx yyyy/mm/dd hh:mm:ss 128
HDLM Driver Ver WakeupTime
Alive x.x.x-xx yyyy/mm/dd hh:mm:ss
License Type Expiration
Permanent -
KAPL01001-I The HDLM command completed normally. Operation name
= view, completion time = yyyy/mm/dd hh:mm:ss
PROMPT>
Installing HDLM after an MSCS Installation
To install MSCS, and then HDLM on a host that does not currently
have HDLM on it:
1
.
Install MSCS on the host.
2
.
Restart the host.
3
.
Log on to Windows as a member of the Administrators group.
4
.
Save the license key file directly under the Windows installation-
destination drive. Also, instead of using the license key file, you can
directly specify the license key during the installation of HDLM.
installation-drive:\hdlm_license
The license key file will be deleted after the installation finishes.
5
.
Perform the installation.
Creating an HDLM Environment
3-39
Hitachi Dynamic Link Manager (for Windows®) User Guide