When mscs is used -56 – HP XP7 Storage User Manual
Page 124
HDLM Manager Ver WakeupTime
Alive x.x.x-xx yyyy/mm/dd hh:mm:ss
HDLM Alert Driver Ver WakeupTime ElogMem Size
Alive x.x.x-xx yyyy/mm/dd hh:mm:ss 128
HDLM Driver Ver WakeupTime
Alive x.x.x-xx yyyy/mm/dd hh:mm:ss
License Type Expiration
Permanent -
KAPL01001-I The HDLM command completed normally. Operation name
= view, completion time = yyyy/mm/dd hh:mm:ss
PROMPT>
21
.
Use the results of the view operation to check the version of the installed
HDLM.
If x.x.x-xx is displayed in HDLM Version, the correct version of HDLM
has been installed.
22
.
Use the results of the view operation to check that the programs are
running properly.
If HDLM Manager, HDLM Alert Driver, and HDLM Driver are all Alive, all
the programs are running correctly.
23
.
Check the path information as described in
, and make sure that you have successfully
installed HDLM in a single-path configuration.
24
.
Connect cables to all the HBAs to change the configuration to a multi-path
configuration.
The following figure shows a single path configuration and a multi-path
configuration.
Figure 3-4 Single Path Configuration and Multi-path Configuration
25
.
Check the path information as described in
to make sure that you have successfully
assembled a multi-path configuration.
When MSCS Is Used
The following provides explanations of how to install MSCS before and after
an HDLM installation.
3-56
Creating an HDLM Environment
Hitachi Dynamic Link Manager (for Windows®) User Guide