HP XP7 Storage - Manual (Page 93)

For Windows Server 2003 (excluding the x86 edition) , Windows
Server 2008 (excluding the x86 edition) or Windows Server 2012,
Program Files is Program Files (x86).
d
.
Restore the setting for Show hidden files and folders that you
changed in step b.
e
.
Rerun the HDLM installation program.
• When installing HDLM on a host where a Device Manager agent 5.0 or
later is installed, do not execute any of the following Device Manager
agent commands during the installation of HDLM:
hbsasrv, HiScan, hdvmagt_account, hdvmagt_schedule, hldutil, TIC
• If you want to install only the HDLM Core components, perform an
unattended installation of HDLM. For details about how to perform an
unattended installation, see The installhdlm Utility for Installing HDLM on
page 7-17 .
• After all HDLM components have been installed on a host, if you want to
create a configuration that uses only the HDLM Core components, you
cannot do so by performing an upgrade installation or re-installation. To
re-configure HDLM with only the HDLM Core components, first remove
HDLM, and then perform an unattended new installation of HDLM.
• If you want to link HDLM to other Hitachi Command Suite products, you
need to install all the HDLM components, not just the HDLM Core
components.
• In Windows Server 2003 SP1 or later, if you change an HDLM
management-target device during an upgrade installation and then
restart the host, the KAPL08019-E and KAPL08022-E messages might be
output, and the path status might change to Offline(E) or Online(E). If
this happens, execute the dlnkmgr command's online operation to
change the path status to Online.
Notes on Migration or Upgrade Installation
If either of the following conditions is met, the disk numbers managed by
Windows might be changed from the state they were in prior to a migration
installation or upgrade installation:
• The disk numbers managed by Windows are non-consecutive and an
HDLM version earlier than 5.4 is migrated to 5.5 or later
• Hitachi's RAID Manager command device is used and an HDLM version
earlier than 5.7 is migrated or upgraded to 5.7.1 or later
If a disk number is changed while the disk is being used by an application,
perform the following:
If the disk number can be changed:
Change the disk number to the number that will be used after the
change.
If the disk number cannot be changed:
Creating an HDLM Environment
3-25
Hitachi Dynamic Link Manager (for Windows®) User Guide