HP XP7 Storage - Manual (Page 295)

Key name #1 Description #2
Necessity of
definition Maximu
m
charact
er
length #
3
New
installat
ion
Upgrade
installat
ion or
Re-
installat
ion
You can specify a value from 1 to
1440. The default is 30.
intermittent_err
or_monitor_numbe
r
#5
Specify how many times an error
needs to occur to cause HDLM to
assume an intermittent error.
You can specify a value from 1 to
99. The default is 3.
Optional Optional 2
dynamic_io_path_
control Specify whether to enable or
disable the dynamic I/O path
control function by using the
values below. Note that, if this
function is set, the setting for each
storage system or LU is cleared.
on: Enabled
off: Disabled (default)
Optional Optional 3
dynamic_io_path_
control_interval
#6
For the dynamic I/O path control
function, specify the checking
interval (in minutes) for reviewing
the information about the
switching of controllers performed
by the storage system.
You can set the checking interval
from 1 to 1440. The default is 10.
Optional Optional 4
remove_lu Specify whether to enable the LU
dynamic removal function by
setting either of the following
values:
on: Enable the LU dynamic
removal function.
off: Disable the LU dynamic
removal function (default).
Optional Optional 3
remove_lu_force Using either of the following
values, specify whether to remove
an LU from the HDLM
management target list when all
paths to the LU are disconnected,
even when there are Offline(C)
paths:
#2
on: Remove the LU.
off: Do not remove the LU
(default).
Optional Optional 3
Utility Reference
7-25
Hitachi Dynamic Link Manager (for Windows®) User Guide