HP XP7 Storage - Manual (Page 180)

When you create a partition, assign the same drive letter as the one
assigned for node A in step 3.
6
.
Stop node B, and then restart node A.
7
.
On node A, register the new LU in MSCS, and set it up.
8
.
Restart node B.
Checking an Added Path
You can add a path, by inserting a cable into an existing LU, even while the
host (on which HDLM is installed) is running.
When you add a path without adding an LU, what is displayed in the disk
management window does not changed.
You can confirm that a path has been added by using the HDLM command
view operation, or the HDLM GUI. The figure below shows an example of how
to use the command to confirm that a path has been added. For an example
of how to use the HDLM GUI to confirm that a path has been added, see the
HDLM GUI Help.
Figure 4-2 Using the command to confirm that a path has been added
Note:
¢
The PathID is determined by the system choosing the smallest,
available number that is not already in use for another path. For
example, when a path is deleted, and then a new path is added, the
PathID for the added path might not be the same number as the
deleted PathID.
¢
When a path not recognized by Windows is added to an LU for the
first time, the following messages might appear:
- KAPL08019-E and KAPL08022-E
4-18
HDLM Operation
Hitachi Dynamic Link Manager (for Windows®) User Guide