HP XP7 Storage User Manual
Page 127
appear if deletion of this file fails. If this happens, delete the file
manually.
13
.
If you want to select an EMC CX series or an HP EVA series LU as the
HDLM management-target device, perform the following steps to register
it. Otherwise, go to step 18.
14
.
From Control Panel, choose MPIO.
The MPIO Properties dialog box opens.
15
.
On the MPIO-ed Devices page, click the Add button.
The Add MPIO Support dialog box opens.
16
.
Enter the Device hardware ID, and then click the OK button.
¢
For an EMC CX series:
Enter DGC RAID for the Device hardware ID.Enter five single-byte
spaces between DGC and RAID.
¢
For an HP EVA series:
Enter HP HSV for the Device hardware ID.Enter six single-byte
spaces between HP and HSV.
17
.
Click the OK button to close the MPIO Properties dialog box.
18
.
Shut down the host.
Leave the host in a single-path configuration until you check (in step 26)
whether HDLM has been successfully installed.
19
.
Perform steps 3 to 18 on all the hosts that make up the cluster system.
20
.
Make sure that all the hosts in the cluster system have completely shut
down.
21
.
Restart each host.
22
.
Log on to Windows again as a member of the Administrators group.
23
.
Execute the dlnkmgr command's view operation to display the status of
each program.
An example of executing the dlnkmgr command's view operation is as
follows:
PROMPT>dlnkmgr view -sys
HDLM Version : x.x.x-xx
Service Pack Version :
Load Balance : on(extended lio)
Support Cluster : off
Elog Level : 3
Elog File Size (KB) : 9900
Number Of Elog Files : 2
Trace Level : 0
Trace File Size(KB) : 1000
Number Of Trace Files : 4
Path Health Checking : on(30)
Auto Failback : on(1)
Remove LU : off
Intermittent Error Monitor : off
Dynamic I/O Path Control : off(10)
HDLM Manager Ver WakeupTime
Alive x.x.x-xx yyyy/mm/dd hh:mm:ss
Creating an HDLM Environment
3-59
Hitachi Dynamic Link Manager (for Windows®) User Guide