HP 9000 rp5400 Servers - Manual (Page 71)

. Flow Control Timeout: 5 minutes.
Do you want to modify the GSP wide parameters? (Y / [N]) __
At this point you can modify the GSP wide parameters, or continue with removing a user.
To remove users, respond N for no.
NOTE: You will have to step through each user number until you reach the user to be
removed.
4. When you access the number of the user to be removed, you must change the data in the
prompts for that number.
It is important that, at a minimum, you need to modify the User's state to Disabled.
Changing the Default GSP Configuration
This section describes the process of changing GSP default configurations. To change the GSP
default configuration, perform the following steps:
1. Go into the GSP with the ctrl+b entry.
2. At the GSP prompt, enter the Default Configuration (dc) command:
GSP> dc
3. Follow the prompts for the dc command, and be sure to have the change information
available.
CAUTION: When the Security configuration is reset, all users are removed, including the GSP
administrator. It also disables the remote. Remote must be re-enabled through the main console
using the Enable Remote (er) command.
Configuring the Rev B Guardian Service Processor (GSP) 71