HP 9000 rp5400 Servers - Manual (Page 33)

• Slots 1 and 2 are reserved for the rp54xx LAN/SCSI and GSP (Guardian Service Processor)
Core I/O cards, respectively. Slots 1 and 2 are non-Turbo slots. Non-Turbo slots share a
single 250MB/s PCI bus and are incapable of HotPlug functionality. The server must be
turned off prior to removing or installing the LAN/SCSI or GSP cards in these slots.
• Slots 3 - 6 are non-Turbo slots. These four Non-Turbo slots share a single 250MB/s PCI bus,
run at 33MHz and support 32 and 64-bit PCI cards. Non-Turbo slots are incapable of HotPlug
functionality. The server must be turned off prior to removing or installing PCI cards in
these slots.
• Slots 7 - 12 are Turbo slots. Each Turbo slot has a dedicated 250MB/s PCI bus, run at 66MHz
and support 32 and 64-bit PCI cards. Turbo slots are HotPlug capable. Below each Turbo
slot is a plastic PCI card separator. The PCI card separator has two LEDs and a pull tab on
the outer edge. The LED's provide power and status for the slot. The pull tab allows the PCI
card to be easily removed.
rp5400 servers have access to slots 1, 2 and 8-12 while rp5450 servers have access to all (1-12)
slots.
NOTE: Slot 3 will become enabled on rp5400 servers with server firmware versions later than
40.48.
A slot 3 enabled label (A5576-84009) is available for rp5400 systems.
rp5470 PCI Card Slots
For rp5470 models, the 10 PCI I/O slots consist of Twin Turbo, Turbo, and non-Turbo slots. The
following illustration shows the PCI card slot layout.
Installing Peripheral Component Interconnect (PCI) Cards 33