HP 9000 rp5400 Servers - Manual (Page 37)

4. Remove the PCI slot cover from the slot that will receive the PCI card. To remove the PCI
slot cover, slide the PCI slot cover away from the server.
5. Slide the PCI card connectors into the slot, snapping firmly in place. For full length (cards
that extend to the left side card guides) PCI cards, use the UPPER card guide.
6. At the rear of the chassis, connect the I/O cable to the card just installed.
7. Replace the right side panel and tighten the captive screws.
8. For rack configurations, insert the rp54xx server back into the rack.
9. For deskside enclosure configurations, replace the deskside enclosure cover.
10. Power the server on.
11. Use the server firmware in io command to verify the PCI cards are recognized by the
server. If AUTOBOOT is ON, it will be necessary to interrupt the boot process to get to the
server firmware Main Menu: Enter command or menu > prompt.
12. Boot HP-UX and run the ioscan utility to verify the system recognizes the new PCI card.
Installing Peripheral Component Interconnect (PCI) Cards 37