Top cover removal – HP 9000 rp5400 Servers User Manual
Page 102
To place the server on its wheeled platform, perform the following procedure:
WARNING!
The stand-alone server weights 69 kg (l50 lbs). Placing the stand-alone server on
its platform requires three people or a suitable lifting device. Failure to heed this precaution can
result in serious personal injury or destruction of the server.
1.
Lift the platform and turn both of the spring-loaded, flat-headed pins (item 1) a quarter turn
to the right to lock them out of the way before placing the server on the platform.
2.
Using a lifting devise or a minimum of three people, lift the server onto the platform. Align
the server and platform so that the pins will lock.
3.
Reach under the platform, locate the spring-loaded, flat headed pins and turn them one
quarter turn to the left to unlock them. Gently slide the server around on the platform until
the spring-loaded flat-head pins snap into their holes.
4.
Once again, reach under the platform on the right side and fasten both front and back
knurl-knobbed, spring-loaded pins (item 2).
To place the cover on a stand-alone server, perform the following procedures:
1.
Set the protective cover on the server and align the holes located near the bottom edge of
both sides of the server cover.
2.
Fasten the screws (with captive washers) through the cover, into the platform.
The following graphic shows the protective cover.
Top Cover Removal
The power to the server does not have to be off to remove the top cover and air baffle. However,
operation of the server without the top cover in place can make it susceptible to EMI problems.
Follow the steps listed below to remove the top cover:
1.
Loosen the captive T-15 screws that hold the top cover in place.
2.
Grasp the strap handles, raise the cover slightly, and pull the cover toward the front of the
server to free the cover tabs from the slots in the chassis. The air baffle will be exposed.
Loosen the captive T-15 screws that hold the air baffle in place then lift the air baffle off of the
server.
102
Removing and Replacing Components