HP 9000 rp5400 Servers - Manual (Page 62)

. Flow Control Timeout: 5 minutes.
Do you want to modify the GSP wide parameters? (Y / [N]) __
At this point you can modify the GSP wide parameters, or continue with removing a user.
To remove users, respond N for no.
NOTE: You will have to step through each user number until you reach the user to be
removed.
4. When you access the number of the user to be removed, you must change the data in the
prompts for that number.
It is important that, at a minimum, you need to modify the User's state to Disabled.
Return the GSP to Default Configurations
The Default Configuration (dc) command is used to reset all or some of the GSP values to the
default values. To return GSP values to default configurations, perform the following steps:
1. Access the GSP with the ctrl+b entry.
2. At the GSP prompt, enter the Default Configuration (dc) command:
GSP> dc
3. Follow the prompts for the dc command, and be sure to have the change information
available.
CAUTION: When the Security configuration is reset, all users are removed, including the GSP
administrator. It also disables the remote. Remote must be re-enabled through the main console
using the Enable Remote (er) command.
rp54xx Server Boot Process
The length of time an rp54xx server will require to complete the boot process depends on the
number of processors and the amount of RAM installed. Average configurations can take more
than 20 minutes.
The boot process consists of the following main steps:
62 Cable Connections