HP 9000 rp5400 Servers - Manual (Page 127)

Platform Monitor Removal
The Platform Monitor resides on the System Board and is accessed via the Top Service Bay.
Removing rp5400 and/or rp5450 Model Platform Monitors
Looking into the Top Service Bay from the front, the rp5400/rp5450 model Platform Monitor is
located on the left side at the front of the server.
To remove the rp5400/rp5450 model Platform Monitor, perform the following steps:
1. Pull up on the extractor levers on each end of the Platform Monitor to unseat it from its
socket.
2. When the Platform Monitor unseats from the socket, pull it up and away from the System
Board.
The following graphics show a Platform Monitor board followed by a display of Platform Monitor
removal/replacement.
Removing The rp5470 Model Platform Monitor
Looking into the Top Service Bay from the front, the rp5470 model Platform Monitor is located
on the right side at the front of the server.
To remove an rp5470 model Platform Monitor, perform the following steps:
Individual Component Remove/Replace Instructions 127