HP 9000 rp5400 Servers - Manual (Page 52)

NOTE: You may use either the arrow keys or the tab key to move between the setting options
on the screen.
1. Press [config keys] function key. [f8]
2. Press [terminal config] function key. [f5]
3. Move to Terminal ID and enter "vt100".
4. Move to Set TermMode and, using the [Prev] and [Next] keys, select "EM100".
5. Press the [config keys] function key. [f8]
6. Press the [ansi config] function key. [f6]
7. Move to "multipage" and, using the [Prev] and [Next] keys, select "yes".
(Enables screen scrolling).
8. Move to Backspace Del and, using the [Prev] and [Next] keys, select "Backspace/Del".
9. Move to EM100 ID and, using the [Prev] and [Next] keys, select "EM100".
Configure the Asynchronous Values of the GSP
After the ASCII console has been configured and physical connections made, make any necessary
changes to the asynchronous values of the GSP.
1. Access the GSP with the ctrl+b entry. The GSP will respond with a GSP> prompt.
2. At the GSP prompt, enter the Configure Asynchronous (ca) command:
The ca command will start a series of prompts. Respond to each prompt with the appropriate
information.
Example 4-1 CA command
Leaving Console Mode - you may lose write access. When Console Mode returns, type ^Ecf to get console write
access.
GSP Host Name: fesrhapgsp
GSP> ca
CA This command allows you to modify the local and remote modem serial portconfigurations.
Current configuration settings:
Local Console Serial Port bit rate: 9600 bits/s
Local Console Serial Port Flow Control: Software
Local Console Serial Port Terminal Type: vt100
Remote Console Serial Port Modem Protocol: CCITT Remote Console Serial Port Modem
bit rate: 19200 bits/s
Remote Console Serial Port Modem Flow Control: Software
Remote Console Serial Port Modem Transmit Configuration Strings: Enabled
Remote Console Serial Port Modem Presence: always connected
Do you want to modify the Local Console Serial Port settings? (Y/[N])
Do you want to modify the Remote Console Serial Port Modem settings? (Y/[N])
GSP Host Name: fesrhapgsp
If necessary, use the GSP help facility by typing GSP>he. Once in the help facility, type the
command need help with. Use LI for a list of commands.
The following baud rates are recommended for the revision A GSP:
•
Console: 19200
• Remote: 19200
• UPS: 1200
The following baud rates are recommended for the revision B GSP:
52 Cable Connections