HP 9000 rp5400 Servers - Manual (Page 24)

13. Use six, M5 x 12 screws (without washers) to attach the tray to the slides. Three screws are
used to attach each slide. Insert the screws through the slides, through the tray and tighten
into the threaded nuts located on the inside of the sides of the tray.
14. From the bottom of the tray pull the plunger pin down and give it a 1/4 turn to hold it in
place.
15. Position the server on the tray aligning the plunger pins with the alignment holes in the
chassis.
16. Release the plunger pins to secure the server.
24 Server Unpacking and Installation