HP 9000 rp5400 Servers - Manual (Page 114)

Grasp the tab at the bottom of the cam latch on the selected disk drive, then push the button
inside the cam latch and pull the cam latch out and up. The disk drive will unlock. Pull gently
until it slides completely free.
The following graphic shows disk features.
The next graphic depicts disk removal/replacement.
HotPlug Disk Drive Replacement
The internal disk drives (up to four) are located at the front right side of the server (as you are
facing it). When proper software and hardware procedures are followed, internal disk drives
can be removed and replaced while the server is running.
CAUTION: Disk Drives can be removed or installed with the server still powered on. This is
referred to as a "manual HotPlug".
However, DO NOT replace a HotPlug disk drive until a controlled shutdown of the operating
system has been performed.
Hardware HotPlug Procedure
To replace a disk drive in the server, grasp the tab at the bottom of the cam latch on the selected
disk drive, push the button inside the cam latch, and pull the cam latch out and up. The disk
drive will unlock. Pull gently until it slides completely free.
The following graphic shows disk features.
114 Removing and Replacing Components