HP 9000 rp5400 Servers - Manual (Page 106)

Front Bezel Removal (Two Piece)
The rp54xx server front bezel is divided and hinged on the right (facing the front of the server)
side to provide a door for Disk Media Bay access. The server does not have to be turned off to
open the access door or to completely remove the bezel.
Opening the door provides access to the following components:
• HotPlug Disks (A0, A1, and B0, B1).
• Removable Media (CD-ROM drive, etc.).
Removing the entire bezel provides access to the components listed above and the following:
• HotSwap Chassis Fan cover.
• HotSwap Chassis Fan 0.
• HotSwap Power Supplies (up to three).
To open the Disk Media access door, grasp the right edge of the door and pull out. The door will
swing away from the chassis, exposing the Disk Media Bay.
To remove the entire bezel, perform the following steps:
1. Open the Disk Media access door, exposing the plastic bezel pins inserted in the clips at the
top and bottom of the Disk Media bay on the left side.
2. Grasp the left side of the bezel and pull it loose.
CAUTION: DO NOT try to pull the bezel off of the server at this point. The plastic pins
holding the bezel on the right side are inserted in metal clips on the Disk Media bay and if
the plastic pins are bent, they will break off.
3. Grasp the bezel with both hands and carefully slide the bezel to the left until both plastic
pins clear the metal clips on the Disk Media bay.
4. Pull the bezel away from the server and set it aside.
The following graphic shows the front bezel.
106 Removing and Replacing Components