HP 9000 rp5400 Servers - Manual (Page 16)

4. Remove the two ramps from the pallet and carefully place them into the slots at the front
of the pallet.
WARNING! Use extreme care when rolling the racked system down the ramps. A rack
containing one rp54xx can weigh up to 418 lbs. Do not stand in front of the ramps when
rolling the cabinet off the pallet or injury may occur. All but the smallest configurations
require two persons to safely remove the rack from the pallet.
If anti-tip feet or ballast are not installed or are improperly installed the cabinet can tip.
Failure to follow this precaution can cause injury to personnel or damage to equipment.
5. Straighten the rollers on the cabinet base, if needed, and carefully roll it down the ramps.
WARNING! After removing the server from the pallet, Do not move the cabinet unless the anti-tip
feet are installed! The cabinet can tip if care is not used. Due to their low ground clearance
the feet may catch on irregularities on the floor, thresholds, or ramps.
Do not move the cabinet without first installing the anti-tip feet. The cabinet may tip if moved
without the anti-tip feet or ballast installed.
Do not move the cabinet after installing the anti-tip feet unless they are in the fully-raised position.
Once installed, the anti-tip feet must be fully raised to allow ground clearance.
Because of their low ground clearance, the fully-raised anti-tip feet may need to be removed
temporarily to clear some obstacles such as door jambs, ramps, and other large irregularities
or obstructions on the floor.
If you must temporarily remove the anti-tip feet to clear an obstacle, use extreme caution
when moving the cabinet. Always reinstall the anti-tip feet as soon as the obstacle has been
cleared.
Lower and secure both the anti-tip feet and the cabinet leveling/stabilizer feet once the
cabinet is in place.
Failure to follow these precautions can result in equipment damage or personal injury.
6. Install the front and rear anti-tip feet using the 1/2 inch bolts provided. Ensure that the
anti-tip feet are installed in the fully up position in the mounting slots. This will provide
maximum ground clearance while moving the cabinet to its final position.
7. Carefully move the cabinet to its installation location.
8. Lower the anti-tip feet to the fully down position and adjust the cabinet leveling feet for best
cabinet stability.
16 Server Unpacking and Installation