HP 9000 rp5400 Servers - Manual (Page 100)

Extend the Server out the Front
rp54xx servers are available in two housings: rack-mounted or stand-alone. Access to servers
mounted in an HP-supported rack is covered in this section.
WARNING! Ensure that all anti-tip features (front and rear anti-tip feet installed; adequate
ballast properly placed, etc.) are employed prior to extending the server.
NOTE: Ensure that there is enough area (Approximately 1.5 meters (4.5 ft) to fully extend the
server out the front and work on it.
To extend the server, perform the following steps:
1. Remove the four T-25 screws that fasten the server to the rack.
2. Grasp the server chassis and slowly pull forward. The server is fully extended when the rail
clips are locked in place. When fully extended, the top and side service bays are fully
accessible.
The following graphic shows the server extended and indicates the rail clip location.
Insert the Server from the Front
rp54xx servers are available in two housings: rack-mounted or stand-alone. Access to servers
mounted in an HP-supported rack is covered in this section.
To return the server into the rack, press the rail clips on either side of the server in and push the
server into the rack until it stops.
The following graphic shows the server extended and indicates the rail clip location.
Stand-alone Server Cover Removal
The rp54xx server can be ordered as a stand-alone unit. In this configuration, the server has a
one-piece protective cover over it and sits on a platform with locking wheels attached.
To remove the cover from a stand-alone server, perform the following procedures:
100 Removing and Replacing Components