HP 9000 rp5400 Servers - Manual (Page 22)

post. The hook points downward. Similarly, place the spacer marked "R" (5183-1863) into
the appropriate slot on the right hand mounting post.
6. Use one M5 x 16 screw with cress-cup washer to attach each spacer to its vertical post. Do
this by inserting the screw through the top hole in the spacer, through the mounting rail
and tightening it into the sheet metal nut located at that position.
7. Take the left hand slide/bracket assembly (marked 337079-1L) and install it into the left hand
vertical mounting posts. This is done by inserting the pin at the rear of the slide's mounting
bracket into the 23rd hole in the rear vertical mounting post and inserting the hook at the
front of the bracket into the vertical, rectangular slot in the aluminum spacer. The slide
should be positioned in the cabinet so that it is horizontal and level.
8. Securely fasten the rear of the slide's mounting bracket to the rear vertical mounting post
by installing and tightening two of the M5 x 16 screws with cress-cup washers thorough the
mounting post, through the slides mounting bracket and into the threaded nuts attached to
the mounting bracket.
9. Fully extend the slide so that it is locked in the fully open position.
22 Server Unpacking and Installation