HP 9000 rp5400 Servers - Manual (Page 103)

The following graphics show the top service bay cover and the air baffle. The first graphic shows
the top service bay cover.
The second shows the air baffle.
Top Cover Replacement
The power to the server does not have to be off to remove or replace the top service bay cover
and air baffle. However, operation of the server without the top cover in place can make it
susceptible to EMI problems.
Set the air baffle in place over the opening for the top service bay and tighten the captive T-15
screws.
Follow the steps listed below to replace the top cover:
1. Align the tabs on the end of the top cover with the corresponding slots in the chassis and
seat the tabs fully into the slots.
2. Seat the top cover in the top of the service bay and tighten the captive T-15 screws that hold
the cover in place.
The following graphics show the air baffle and the top service bay cover. The first graphic shows
the air baffle.
The second graphic shows the top service bay cover.
Individual Component Remove/Replace Instructions 103