HP 9000 rp5400 Servers - Manual (Page 19)

Install Deskside Server
The following section describes the installation of a server into a Deskside enclosure for installation
in an office environment.
WARNING! The typical rp54xx system can weigh up to 68kg (150lbs). HP recommends using an
approved lifting device.
•
Lift and move the server in accordance with all local safety regulations.
• Do not attempt to lift the server by the plastic handles on the top and side covers.
Failure to follow these precautions can cause injury to personnel or damage to equipment.
1. Unpack the server.
2. Unpack the deskside enclosure.
NOTE: Ensure that the positioning spring pins in the enclosure base align with the
alignment holes in the bottom of the server.
3. Position the server on the wheeled enclosure base.
4. Tighten the two captive screws in the enclosure base to secure the server to the base.
5. Position the enclosure cover (outside skin) over the server and install and tighten the screws
to secure it to the base.
Install Deskside Server 19