HP 9000 rp5400 Servers - Manual (Page 21)

1. Determine what type of cabinet you are installing the slide-tray assembly into.
a.
E-Series cabinets have:
•
Parchment white, plastic, sectional, side panels
• Black painted vertical frame posts with a partial return flange.
b. Approved, non-E-Series, cabinets have:
•
Single piece metal side panels
• Gray painted verticle frame posts with full return flanges.
2. Note the vertical, rectangular, slots in the return flanges on the vertical mounting posts.
Determine into which of these vertical slots the slide/tray kit will be installed. This is done
by counting down eight rectangular slots from the top of the cabinet or the bottom of the
equipment above.
3. On the front vertical mounting posts only, slide M5 sheet metal nuts onto the posts over the
holes immediately adjacent to the vertical slots determined in the previous step. Also place
M5 sheet metal nuts on the holes directly above these. Orient the sheet metal nuts so that
the threaded portion faces towards the outside of the cabinet. There should now be a total
of four (4) sheet metal nuts installed.
4. If the cabinet is a non-E-Series cabinet, discard the left hand and right hand aluminum
spacers and two of the M5 x 16 screws with cress-cup washers and proceed to step 12.
5. If the cabinet is an E-Series cabinet, place the hook of the aluminum spacer marked "L"
(5183-1864) into the appropriate vertical, rectangular slot on the front, left hand mounting
Install Stand-Alone Server in a Cabinet 21