HP 9000 rp5400 Servers - Manual (Page 39)

• Slots 1 and 2 are reserved for the rp54xx LAN/SCSI and GSP (Guardian Service Processor)
Core I/O cards, respectively. Slots 1 and 2 are non-Turbo slots. Non-Turbo slots share a
single 250MB/s PCI bus. Non-Turbo slots are incapable of HotPlug functionality. The server
must be turned off prior to removing or installing the LAN/SCSI or GSP cards in these slots.
• Slots 3 - 6 are non-Turbo slots. These four Non-Turbo slots share a single 250MB/s PCI bus,
run at 33MHz and support 32 and 64-bit PCI cards. Non-Turbo slots are incapable of HotPlug
functionality. The server must be turned off prior to removing or installing PCI cards in
these slots.
• Slots 7 - 12 are Turbo slots. Each Turbo slot has a dedicated 250MB/s PCI bus, run at 66MHz
and support 32 and 64-bit PCI cards. Turbo slots are HotPlug capable. Below each Turbo
slot is a plastic PCI card separator. The PCI card separator has two LEDs and a pull tab on
the outer edge. The LED's provide power and status for the slot. The pull tab allows the PCI
card to be easily removed.
rp5400 servers can access PCI slots 1,2 and 8-12. rp5450/3000 servers can access all PCI slots.
Follow these procedures to install graphics cards.
1. Install HP-UX 11.0 Support Plus (IPR) 0006, June 2000 or later. This step ensures the
appropriate HP-UX drivers are installed.
2. Power down and unplug the rp54xx server.
NOTE: DC voltages are present when the server is connected to AC power. Do not attempt
to install or service: CPUs, Memory, PSMs, the Platform Monitor or PCI I/O cards installed
in non-Turbo slots (1-6) while DC voltage is present. Failure to observe this warning may
result in damage to the server.
3. Make the right side of the server accessible for service.
4. Using a Torx 15 screwdriver, loosen the captive screws on the right side panel. This panel
has a label which shows which PCI I/O slots are available and the corresponding paths. The
label shown below is for an rp5400.
Installing Graphics 39