HP 9000 rp5400 Servers - Manual (Page 25)

Stationary L-Bracket Rail Assembly
rp54xx servers may be installed into E-Series and approved Non- E-Series cabinets using stationary
L-bracket rail assembly kits listed below.
NOTE: rp54xx servers are supported in Hewlett-Packard E-series and approved Non- E-series
Hewlett-Packard cabinets, and approved rail kits.
For information on additional qualified 3rd party cabinets and rail kits, contact the nearest
Hewlett-Packard Response Center.
Rail Kit Product Number Cabinet Type
A5575A E-Series HP Cabinet
A5562A Other Approved HP Cabinet
Identifying Approved Non-E-Series HP Cabinets
Approved Non- E-Series cabinets have black frames, one piece outside sheet metal skins, a partial
return flange, and requires the installation of the aluminum spacer blocks, supplied with the rail
kits.
Approved Non- E-Series cabinets include the following product numbers: A1883A, A1884A,
A1896A, A1897A, C1897A, C2785A, C2786A, and C2787A.
Identifying E-Series HP Cabinets
E-Series cabinets have light gray frames, sectioned, plastic outside "skins", a full return flange,
and does not require the installation of the aluminum spacer block supplied, with the rail kits.
Stationary L-Bracket Rail Assembly 25