HP 9000 rp5400 Servers - Manual (Page 27)

1. Locate the rail mounting height in the cabinet. Allow for the following space requirements:
•
For each rp54xx server, allow 31.8cm (12.5 inches) vertically (7 EIAs or Rack Units (RUs).
• If installing the A5575A rail kit, allow an additional vertical 4.45cm (1.75 inches (1 EIA)
each set of rails.
2. Install sheet metal nut(s) in the vertical cabinet posts at the required height for the kit being
installed:
•
Install the first nut either:
— 4.45 cm (1.75 Inches) above the top, or
— 31.8 cm (12.5 inches) below the bottom of the last server.
• If installing a A5562A rail kit, install the second nut in the next frame hole below the
first.
3. Hold the rail in place and insert and tighten the screws.
For installation of other qualified cabinet and rail combinations refer to the safety precautions
and instructions accompanying them.
Stationary L-Bracket Rail Assembly 27