HP 9000 rp5400 Servers - Manual (Page 42)

10. Replace the right side panel and tighten the captive screws.
11. For rack configurations, insert the rp54xx server back into the rack.
12. For deskside enclosure configurations, repalce the deskside enclosure cover.
13. Power the server on.
14. Use the server firmware in io command to verify the graphics cards are recognized by
the server. If AUTOBOOT is ON, it will be necessary to interrupt the boot process to get to
the server firmware Main Menu: Enter command or menu > prompt.
15. Boot HP-UX and run the ioscan utility to verify the system recognizes the new PCI card.
16. Logon as root and install X/CDE/Motif if not already installed.
Graphics Troubleshooting
This section describes how to troubleshoot common problems encountered during installation
or attempted use of graphics. The following system utilities can be used to display or set the
graphics configuration:
•
/opt/graphics/common/bin/graphinfo allows you to display the current graphics
configuration and the graphics drivers that are being used.
• /opt/graphics/common/bin/setmon allows you to reconfigure the monitor type.
• The display menu of the HP-UX System Administration Manager (SAM) utility allows
you to configure the X-Server and set the monitor type.
42 Installing Additional Components