HP 9000 rp5400 Servers - Manual (Page 17)

Receive and Unpack A Non-Integrated Server
WARNING! The typical rp54xx system can weigh up to 68kg (150lbs). HP recommends using an
an approved lifting device. Lift and move the server in accordance with all local safety regulations.
Failure to follow this precaution can cause injury to personnel or damage to equipment.
Unpacking the server
The following procedure describes the steps involved in unpacking the server, whether to function
as a stand-alone Deskside unit, or to be integrated into a cabinet.
1. Remove the shipping carton and anti-static bag from the server as depicted below.
NOTE: The packaging for rp74xx and rp54xx servers is the same, rp74xx is shown.
2. If you are moving the server manually, use three people to lift the server from the packing
material and pallet. Carefully move the server to the selected location.
3. If you are moving the server by an approved lifting device (such as Genie Lift ™), remove
the tear flap from the front lip of the carton bottom to allow access to the server, as illustrated
below. Removal of the tear flap will reveal a slot between the bottom of the server and the
inside bottom of the cardboard box.
Receive and Unpack A Non-Integrated Server 17