HP 9000 rp5400 Servers - Manual (Page 23)

10. Use an M5 x 30 screw with a cress cup washer to attach the front of the slide to the vertical
mounting post. Insert the screw through the slide, through the center hole of the aluminum
spacer, through the vertical mounting post, and tighten into the sheet metal nut located at
that position.
11. Use a procedure similar to steps 7 through 10 to install the right hand slide/bracket assembly
(marked 337079-1R) and then proceed to step 12.
12. Take the tray and place it onto the pins that extend from the slides' inner members. The slots
with wide lead-in guides on the side of the tray fit down onto the slides' pins. The flat part
of the tray will be on top, and the mounting holes in the top of the tray will be located to
the right of the center of the tray. Slide the tray all the way down on both sides so that the
pins reach the top of the slots in the side of the tray.
Install Stand-Alone Server in a Cabinet 23