Installing a pci card – HP 9000 rp5400 Servers User Manual
Page 36
4.
Requires server firmware revision 39.46 or later.
5.
Requires HP-UX 11.1
6.
Maximum is 7 for HP-UX versions prior to 11.0. Maximum is 10 for HP-UX version 11.1 and
later.
7.
Requires PHKL_19543 and PHKL_19544 or their superseded equivalents.
8.
Requires HP-UX 11.0 Support Plus (IPR) 0006, June 2000 or later. This product to be released
6/00.
9.
Not supported in a shared slot (slots 3-4 for rp5470, slots 3-6 for rp5450, not applicable for
rp5400).
10. If you are installing ATM 622 cards in an rp5470 configuration, do not install them in slots
3 and 4 (shared slots).
11. Requires 768 MB for first card and 512 MB for each additional card.
12. Not supported in shared slots.
13. Max of 1. Needs USB card for keyboard and mouse.
14. Contains PCI bridge.
Installing a PCI Card
Follow these procedures to install a PCI card.
1.
Power down and unplug the rp54xx server.
NOTE:
DC voltages are present when the server is connected to AC power. Do not attempt
to install or service: CPUs, Memory, PSMs, the Platform Monitor or PCI I/O cards installed
in non-Turbo slots (1-6) while DC voltage is present. Failure to observe this warning may
result in damage to the server.
2.
Make the right side of the server accessible for service.
3.
Using a Torx 15 screwdriver, loosen the captive screws on the right side panel. This panel
has a label which shows which PCI I/O slots are available and the corresponding paths. The
PCI I/O slot paths for rp5400, rp5450, and rp5470 are shown below.
rp5430/rp5470
rp5450
rp5400
Slot
Path
Slot Type
Path
Slot/Type
Path
Slot Type
0/10/0
Twin Turbo
0/4/0
Turbo
0/4/0
Turbo
12
0/12/0
Twin Turbo
0/7/0
Turbo
0/7/0
Turbo
11
0/8/0
Turbo
0/3/0
Turbo
0/3/0
Turbo
10
0/9/0
Turbo
0/6/0
Turbo
0/6/0
Turbo
9
0/3/0
Turbo
0/2/0
Turbo
0/2/0
Turbo
8
0/1/0
Turbo
1
0/5/0
Turbo
Not Available
7
0/5/0
Turbo
1
0/1/0
Shared
Not Available
6
0/2/0
Turbo
1
0/1/1
Shared
Not Available
5
0/4/0
Shared
1
0/1/2
Shared
Not Available
4
0/4/2
Shared
0/1/3
Shared
Not Available
2
3
GSP
GSP
GSP
2
LAN/SCSI
LAN/SCSI
LAN/SCSI
1
1
Slot is NOT AVAILABLE for rp5430.
2
Slot 3 becomes available with server firmware versions later than 40.48.
36
Installing Additional Components