HP Hitachi Dynamic Link Manager Software - Manual (Page 215)

The following sub-parameter can be used to specify how the LU dynamic
deletion function operates.
-force
The LU is removed from under HDLM-management when all the paths
to the LU are disconnected, even when an Offline(C) path is
included in the paths connected to the LU.
For details on the LU dynamic deletion function, see Deleting an LU
Dynamically on page 4-19 .
Table 6-7 Values for the LU Dynamic Deletion Function on page 6-27
shows the values of the LU dynamic deletion function.
Table 6-7 Values for the LU Dynamic Deletion Function
Value Description
off The LU will not be removed from under HDLM-management, even if an
error occurs on all the paths to the LU, all the paths to the LU are
disconnected, or the LU is deleted. The path statuses are Offline(E)
and Online(E). This operation is the same as the in HDLM 05-01 or
earlier. The off option is recommended when you want to use the
same function as you used before in HDLM 05-01 or earlier, without
using the LU dynamic deletion function.
on The LU is removed from HDLM-management when all the paths to the
LU are disconnected. However, if an Offline(C) path is among the
disconnected paths, the LU will not be deleted from HDLM-
management.
The deleted LU is restored after it is recovered from the physical failure
and the disk is re-scanned.
on -force The LU is removed from HDLM-management when all the paths to the
LU are disconnected, even when an Offline(C) path is included.
The removed LU is restored after it is recovered from the physical
failure and the disk is re-scanned.
-audlog {on [-audlv audit-log-data-collection-level] [-category
[[ss][a][ca]|all]]|off}
Specifies whether to collect audit log data.
on: Audit log data is collected.
off: Audit log data is not collected.
-audlv audit-log-data-collection-level
Specifies the severity level that determines the selection of audit log
data to be collected. Table 6-8 Values Indicating Audit Log Data
Collection Levels on page 6-27 lists the values that indicate audit log
data collection levels. The default is 6.
Table 6-8 Values Indicating Audit Log Data Collection Levels
Value (severity) Explanation
0 Error-level audit log data is collected.
Command Reference
6-27
Hitachi Dynamic Link Manager User Guide (for Windows(R))