HP Hitachi Dynamic Link Manager Software User Manual
Page 102
¢
In the last installation window, the following message might be
output:
When you manage a host by using Global Link Manager and
Windows firewall is enabled on that host, execute the
firewall_setup command to allow a firewall exception.
If Global Link Manager will not be used to manage HDLM, you do not
need to take any action.
To manage HDLM with Global Link Manager, register Firewall
exceptions. For details, see
Firewall Settings for Managing HDLM by
Using Global Link Manager on page 3-66
.
15
.
Check the results of the installation.
If you have performed an unattended installation, check the installation
results from the command prompt.
16
.
After the installation finishes, execute the dlmprsvkey utility with the -v
parameter specified.
Execute the following command:
HDLM-installation-folder\bin\dlmprsvkey -v
Make sure that the PRSV key displayed by the dlmprsvkey utility is
unique among all the other hosts in the SAN. If the PRSV key is not
unique or is not registered, or if the KAPL09131-W message appears,
execute the dlmprsvkey utility with the -r parameter specified to re-
register the PRSV key. If the PRSV key is not registered, the HDLM
functions might not properly operate. For details about the dlmprsvkey
The dlmprsvkey Utility for Registering an HDLM Persistent
.
If you used a license key file, it will be deleted after the installation
finishes. The KAPL09115-W message will appear if deletion of this file
fails. If this happens, delete the file manually.
17
.
Shut down the host.
Leave the host in a single-path configuration until you check (in step 24)
whether HDLM has been successfully installed.
18
.
For all the hosts that make up the cluster system, perform steps 3 to 16.
19
.
Make sure that all the hosts that make up the cluster system have been
completely shut down.
20
.
Restart each host.
21
.
Log on to Windows again as a member of the Administrators group.
22
.
Execute the dlnkmgr command's view operation to display the status of
each program:
An example of executing the dlnkmgr command's view operation is as
follows:
>dlnkmgr view -sys
HDLM Version : x.x.x-xx
Service Pack Version :
Load Balance : on(extended lio)
Support Cluster : off
3-36
Creating an HDLM Environment
Hitachi Dynamic Link Manager User Guide (for Windows(R))